POWER Burner Cutout Kit (not a drop down kit)
Use for all power burners with up to a 24" wide cutout
Non-Telescoping Includes:
2 ea Steel Tubes 24" x 40mm
2ea CTT Tubes 28 3/4" for left and right side of burner
2ea 3 Way Corner Couplers
6ea 1 Way couplers
Note: You will use the two vertical tubes from the module for the right and left side burner supports. These will connect to the included 3 way corner couplers leaving you two extra one way couplers that you will use for the CTT's saving you money.
Description:
This item is the extra tubes and connectors needed to make a power burner cutout into the top of your BBQ Tubes module frame including our Amazing No Cut Connectors for below and behind the side burner.
This is not a drop down kit where you want the power burner to be 12" below the counter top.
It will work for all built-in power burners with a 15 3/4-22 1/2" wide cutout width that are supported on the counter top such as Bull, Cal Flame, Fire Magic, Summerset, Napolean, etc...
Some high end slide in power burners will require you to make a platform frame in addition to this cutout opening.
For platform side burners you will buy extra tubes and one way connectors sold as a side burner platform kit in addition to this universal grill kit.
What's Not Included:
power burners with a cutout less than 15 3/4"will require you to trim the tubes as needed.
This kit does not include the actual bar center, cement board, a 4ft module, screws, etc...
ASSEMBLY REQUIRED - No Screws Included